Clean the area where the overlay is to be applied with isopropyl rubbing alcohol and a clean microfiber cloth or 100% terry cotton towel to remove all wax, RainX, dirt and oils.
#IMAGECAST VINYL OVERLAY PRO#
pro tip: Use a small amount of dish soapģ. Wash hands to remove oils that may transfer to vinyl. Ambient and surface temperature where you're installing should be between 60☏ (16☌) to 90☏ (32☌)Ģ. We've tested them by going through multiple car washes and heavy rain at 75 MPH sustained for at least 5 Hours. Our overlays will last 5-7 years in sunlight, rain, wind and snow. If your overlay does not fit, something is wrong, please contact us. These overlays are designed to fit precisely, there should be no stretch required. They also can be repositioned as long as pressure hasn't been applied. Multi-layered vinyl overlays base layers are made from premium cast vinyl with air release technology that is to be applied dry. If some small bubbles remain leave them to temp cycle a few days as vinyl is porous and may vent the trapped air naturally. Pull and slide the tape slowly at 180° to remove the tape. Remove the transfer tape by lifting and folding the sticky side up on a corner of the tape. *Apply the decal using a squeegee to push out air and water solution to stick the decal fully to the surface from the center out. Apply the decal using a squeegee to push out air and stick the decal fully to the surface from the center out.ħa. Apply, position and align the decal to where it is to be placed. Spray the area to be applied and the sticky side of the decal, once the backing paper is removed. Mix water into an 8 ounce spray bottle with 1 drop of dish soap. *Optional step for decals that require intricate exact placement. If not re-apply the transfer tape and use pressure with a squeegee to get the transfer tape to stick to the decal fully.Ħa.
Remove the backing paper carefully, making sure that all parts of the decal have been stuck to the transfer tape. Make sure the decal is applied well to the transfer tape by applying pressure with a squeegee or plastic card.Ħ. You can use painters tape to hold the decal to create a boundary of where to apply or to hinge the decal.ĥ. Measure or position the vinyl for placement. Note: Alcohol will cool the surface a little from evaporation, make sure the temp is within tolerance.Ĥ. Clean the area where the decal is to be applied with isopropyl rubbing alcohol and a clean microfiber cloth or terry cotton towel to remove all wax, RainX, dirt and oils. Then dry the area thoroughly. Wash your hands to remove oils that may transfer to vinyl. Ambient air and surface temperature where you're installing should be between 60☏ (16☌) to 90☏ (32☌)Ģ.
0 kommentar(er)
